LaserPecker
Study Stamps
How-to
- Machine
- LP5
- Material
- Plastic
- Size
- 50 x 50 mm
- Software Used
- LaserPecker Design Space PC
- Production Time
- 45 min
- Engraving Difficulty
Design Files
2024/11/01 19:4444
Introduction
Try making cute stamps with Laserpecker LP5! You can laser cut the rubber and do deep engraving.
How-to Tutorial
Step1:
Connect the machine and open the file. Begin by placing a piece of 2mm rubber on the cutting plate. Adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start engraving and cutting at the same time.
After the engraving is complete, use a toothbrush and cleaning agent to clean the dust from the surface, and finally attach it to the stamp base.
Settings 1
FillPlastic
- Engraving Method
- Fill
- Material
- Plastic
- Resolution
- 2 K
- Power
- 50%
- Depth
- 70%
- Pass
- 1
- Module Type
- 20W 450nm
Settings 2
LinePlastic
- Engraving Method
- Line
- Material
- Plastic
- Power
- 70%
- Depth
- 80%
- Pass
- 100
- Module Type
- 20W 450nm
School
Comments