LaserPecker
Obile Phone Charging Stand
How-to
- Machine
- LX1
- Material
- Wood
- Size
- 167 x 124 mm
- Material Information
- 3mm Basswood Plank
- Software Used
- LaserPecker Design Space PC
- Production Time
- 15 min
- Engraving Difficulty
Design Files
2024/05/06 16:3939
Introduction
A phone charging shelf is convenient when you need to charge your phone but there is no table or other surface near the wall socket.
How-to Tutorial
Step1:
Open the file and connect the machine. Begin by placing a 3mm basswood plank on the cutting plate. Adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start engraving and cutting.
This file is only applicable to 3mm basswood planks. Other thicknesses of wood may not be able to be assembled. Additionally, if you use different materials, you will need to adjust the parameters yourself.
Settings 1
- Engraving Method
- Fill
- Material
- Wood
- Resolution
- 2 K
- Power
- 60%
- Depth
- 3%
- Pass
- 1
- Acceleration Level
- 1
- Module Type
- 20 W 450 nm
Settings 2
- Engraving Method
- Line
- Material
- Wood
- Power
- 70%
- Depth
- 80%
- Pass
- 1
- Acceleration Level
- 1
- Module Type
- 20 W 450 nm
Step2:
Assemble the cut parts and use glue in the gaps to make it more sturdy.
Good Life
Sharing Good Finds
Comments