LaserPecker

Wooden Tube Rack

How-to
Machine
LX1
Material
Wood
Size
185 x 94 mm
Material Information
3mm Basswood Plank
Engraving Difficulty

Design Files

Wooden Tube Rack.lp2
2024/03/02 18:567

Introduction

Create a wooden test tube vase holder to adorn your life in a unique way.

How-to Tutorial

1

Step1:

Open the file and connect the machine. Begin by placing a 3mm basswood plank on the cutting plate. Adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start cutting.

This file is only applicable to 3mm basswood planks. Other thicknesses of wood may not be able to be assembled. Additionally, if you use different materials, you will need to adjust the parameters yourself.

组 2-1.jpg组 4-1.jpg组 5-1.jpg

After being assembled, it can hold test tubes with a diameter of 15mm.

Settings 1

Engraving Method
Line
Material
Wood
Power
70%
Depth
80%
Pass
1
Acceleration Level
1
Module Type
20 W 450 nm
Good Life
Flower

Comments