Jantsa
Engraving on denim / jeans
How-to
- Machine
- LP4
- Material
- Cloth
- Size
- 10 x 5 mm
- Material Information
- Blue jeans dress
- Software Used
- LaserPecker Design Space PC
- Production Time
- 4 min
- Engraving Difficulty
Design Files
2024/02/05 04:3042
Introduction
Important: make jeans wet first. Put the jeans under the tap and wet them, then wring them out and then you can place then under laser for engraving.
How-to Tutorial
Step1: Important: make jeans wet first. Put the jeans under the tap and wet them, then wring them out.
Each denim though react differently, start first lower depth and power to test out. You can always make the second pass as well but not more than 2 as I have found with experience that 3 passes is already too much for the threads. This dress is made with one pass, but some jeans material stay too light with first pass and might need the second pass as well. When engraving on denim, a thicker design with not many fine lines will do better, as they will burn the threads, the laser is too sharp.
Settings 1
FillCloth
- Engraving Method
- Fill
- Material
- Cloth
- Resolution
- 1 K
- Power
- 50%
- Depth
- 2%
- Pass
- 1
- Module Type
- 10 W 450 nm
Decorative Painting
My Handmade Daily
Atmospheric Decoration
Comments