Open in LDS
Family Keychains Board
How-to
LaserPecker
2024/01/13 12:35 50
Make a family keychains Board that you can attach to the entranceway for family members to place their keys.
Basic Information
| MachineLX1 |
| MaterialWood |
| Size178 x 209 mm |
| Software UsedLaserPecker Design Space PC |
| Production Time30 min |
| Engraving Difficulty |
How-to Tutorial
Step 1
Open the file and connect the machine. Begin by placing a 3mm basswood plank on the cutting plate. Adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start engraving and cutting.
Note that if you're using planks or materials of different thicknesses, remember to adjust the parameters accordingly.
Settings 1
| Engraving MethodLine |
| MaterialWood |
| Power70% |
| Depth80% |
| Pass1 |
| Acceleration Level1 |
| Module Type20 W 450 nm |
Step 2
Put the wooden figurines on the key rings. Overlap and paste the two house shapes, and then you can stick them on the wall.
Design Files
LaserPecker Design Space V2.5.1 or above is recommended.
Family Keychains.lp2
Open in LDSDownload
9
Good Life
Family
