LaserPecker
Wooden Tulips
How-to
- Machine
- LX1
- Material
- Wood
- Size
- 224 x 249 mm
- Software Used
- LaserPecker Design Space PC
- Production Time
- 30 min
- Engraving Difficulty
Design Files
2024/01/12 20:305
Introduction
Let's make some wooden tulips.
How-to Tutorial
Step1:
Open the file and connect the machine. Begin by placing a 4mm basswood plank on the cutting plate. Adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start cutting.
This file is only applicable to 4mm basswood planks. Other thicknesses of wood may not be able to be assembled. Additionally, if you use different materials, you will need to adjust the parameters yourself.
Settings 1
- Engraving Method
- Line
- Material
- Wood
- Power
- 80%
- Depth
- 80%
- Pass
- 1
- Acceleration Level
- 1
- Module Type
- 20 W 450 nm
Step2:
Paint the wood pieces with your favorite colors, and after the paint dries, assemble the wood pieces according to the corresponding shapes.
Flower
Comments