LaserPecker
Rainbow Snowflake Watch Bands
How-to
- Machine
- LP4
- Material
- Plastic
- Size
- 118 x 118 mm
- Software Used
- LaserPecker Design Space PC
- Production Time
- 30 min
- Engraving Difficulty
Design Files
2024/01/29 15:5926
Introduction
Let's see how to make rainbow snowflake watch bands.
How-to Tutorial
Step1:
Open the file, connect the the LP4. Remove the watch bands, place them on the base in order. adjust the focus, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start engraving.
Settings 1
FillPlastic
- Engraving Method
- Fill
- Material
- Plastic
- Resolution
- 2 K
- Power
- 100%
- Depth
- 25%
- Pass
- 2
- Module Type
- 2 W 1064 nm
Step2:
The pattern is engraved. After cleaning the dust on it, it can be worn on the hand.
Go ahead and give it a try.
Step3: Note
Since the engraved pattern is larger than the material, you can place a piece of unused material under the material to protect your machine.
Christmas
Snow
Watch Band
Comments