LaserPecker

Valentine's Day Photo Frame

How-to

Machine: LX1
Material: Wood
Size: 367 x 221 mm
Material Information: 3mm Basswood Plank, 1.5mm Basswood Plank
Software Used: LaserPecker Design Space PC
Production Time: 30 min
Engraving Difficulty

Design Files

Valentine's Day Photo Frame-01.lp2

2024/01/28 15:0313

Introduction

Valentine's Day is approaching. Use the machine to make a festive photo frame and fill it with the photo of wonderful moments full of memories.

How-to Tutorial

Step1:

Open the file and connect the machine. Begin by placing a 3mm basswood plank on the cutting plate. Adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start engraving and cutting.

This file is only applicable to 3mm basswood planks. Other thicknesses of wood may not be able to be assembled. Additionally, if you use different materials, you will need to adjust the parameters yourself.

Settings 1

FillWood

Engraving Method: Fill
Material: Wood
Resolution: 2 K
Power: 30%
Depth: 3%
Pass: 1
Acceleration Level: 1
Module Type: 20 W 450 nm

Settings 2

LineWood

Engraving Method: Line
Material: Wood
Power: 70%
Depth: 80%
Pass: 1
Acceleration Level: 1
Module Type: 20 W 450 nm

Step2:

Begin by placing a 1.5mm basswood plank on the cutting plate. Adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start engraving and cutting.

This file is only applicable to 1.5mm basswood planks. Other thicknesses of wood may not be able to be assembled. Additionally, if you use different materials, you will need to adjust the parameters yourself.

组 3.jpg 组 7.jpg

As shown in the figure, attach the 1.5mm wooden pieces to the backboard and press it together with the front board. Add the base and the text plate, and the photo frame is ready. Go ahead and put in your photo.