LaserPecker
Family Keychains Board
How-to
- Machine
- LX1
- Material
- Wood
- Size
- 178 x 209 mm
- Software Used
- LaserPecker Design Space PC
- Production Time
- 30 min
- Engraving Difficulty
Design Files
2024/01/13 12:3552
Introduction
Make a family keychains Board that you can attach to the entranceway for family members to place their keys.
How-to Tutorial
Step1:
Open the file and connect the machine. Begin by placing a 3mm basswood plank on the cutting plate. Adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start engraving and cutting.
Note that if you're using planks or materials of different thicknesses, remember to adjust the parameters accordingly.
Settings 1
LineWood
- Engraving Method
- Line
- Material
- Wood
- Power
- 70%
- Depth
- 80%
- Pass
- 1
- Acceleration Level
- 1
- Module Type
- 20 W 450 nm
Step2:
Put the wooden figurines on the key rings. Overlap and paste the two house shapes, and then you can stick them on the wall.
Good Life
Family
Comments