LaserPecker
Wooden Cat Pen Holder
How-to
- Machine
- LX1
- Material
- Wood
- Size
- 354 x 401 mm
- Material Information
- 3mm Basswood Plank
- Software Used
- LaserPecker Design Space PC
- Production Time
- 30 min
- Engraving Difficulty
Design Files
2024/01/05 19:1846
Introduction
Make a wooden cat pen holder to store your pens.
How-to Tutorial
Step1:
Open the file and connect the machine. Begin by placing a 3mm basswood plank on the cutting plate. Adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start cutting.
This file is only applicable to 3mm basswood planks. Other thicknesses of wood may not be able to be assembled. Additionally, if you use different materials, you will need to adjust the parameters yourself.
Settings 1
LineWood
- Engraving Method
- Line
- Material
- Wood
- Power
- 70%
- Depth
- 80%
- Pass
- 1
- Acceleration Level
- 1
- Module Type
- 20 W 450 nm
Step2:
As shown in the picture, paste the four wooden boards of the cat together to form two pieces. . And the five wooden pieces are spliced together, and glue is filled in the gaps to make it more secure. The wooden cat pen holder is ready.
Pen Holder
Cat
Comments