LaserPecker
Christmas Gift Box
How-to
- Machine
- LX1
- Material
- Paper
- Size
- 282 x 282 mm
- Material Information
- 0.6mm Kraft Paper
- Software Used
- LaserPecker Design Space PC
- Production Time
- 30 min
- Engraving Difficulty
Design Files
2023/12/21 11:598
Introduction
Use the machine to create a Christmas gift box.
How-to Tutorial
Step1:
First，open the file and connect the machine. As shown in Picture 1 and Picture 2, click the cutting button to place the layer in the line model to the to cut model. This allows you to cut while drawing lines.
Place a piece of kraft paper on the cutting plate, adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start cutting.
Settings 1
LineKraft paper
- Engraving Method
- Line
- Material
- Kraft paper
- Power
- 60%
- Depth
- 10%
- Pass
- 1
- Acceleration Level
- 1
- Module Type
- 20 W 450 nm
Settings 2
CutKraft paper
- Engraving Method
- Cut
- Material
- Kraft paper
- Power
- 60%
- Depth
- 80%
- Pass
- 1
- Acceleration Level
- 1
- Module Type
- 20 W 450 nm
Step2:
Use the red area shown in Figure 2 to apply glue, and then assemble the box as shown in the pictures. Tie a ribbon on the top, and place an atmosphere lamp inside. The Christmas gift is ready.
Step3: Note
If you're using different materials, remember to adjust the parameters accordingly.
Christmas
Gift Box
Comments