Ghost Cat Leather Patch & Keychain

How-to
avatar
DavE
2024/11/15 10:12 15
Ghost cat leather patch & don't make my claws come out keychain

Basic Information

MachineLP4
MaterialLeather/Wood
Size30 x 51 mm
Material InformationWood keychain is from Amazon and the leather patch is from the LaserPecker material pack
Engraving Difficulty
Firmware version ≥655

How-to Tutorial

Step 1 Upload image to LP and size viewing box to fit your patch or keychain size.

Upload image to LP and size viewing box to fit your patch or keychain size. Use Veranda font in the LP app to type the words "Don't Make My" hit ok and change the text alignment to center. Adjust the width of the text to be the same width as your cat image. Move the words above the image to put it in the desired place the proceed to do the same steps for the words "Claws Come Out" place this text below the cat image then begin engraving. Both the keychain and leather patch were made on the exact same LP app settings listed here. You do not need to invert the image.

Settings 1

Engraving MethodPicture
MaterialLeather
Resolution1 K
Power50%
Depth3%
Pass1
Module Type10 W 450 nm

Design Files

LaserPecker Design Space V2.5.1 or above is recommended.

logo
Spooky Cat.JPG
Halloween
Cat
Ghost
Keychain
Patch