Christmas Woodland Coaster Set

How-to

Crafted Curiosity

2024/11/13 23:32 103

Set of 4 Slate Coasters - Christmas Woodland Designs

Basic Information

MachineLP4

MaterialStone/Slate

Size101 x 101 mm

Material InformationSlate Coasters purchased from Amazon

Production Time45 min

Engraving Difficulty

Firmware version <655

How-to Tutorial

Step 1 Set image to 2k and invert image before engraving

DO NOT Pre-Treat or Sand Coasters beforehand. (Coating Coasters Before Engraving Releases Fumes that are Seriously Harmful to your Health) Place Coasters on Engraving Plate and Size the Viewing Box area just enough to go over the edge of the coaster. Make sure each image is inverted and select dithering. Each coaster will take roughly an hour due to the amount of detail and shading. After you're finished engraving spray coat coasters with Mod Podge Matte clear acrylic sealer to achieve my exact results. All image files are marked by name. (Fox, Deer, Santa, and Racoon)

FOR LP2 (5w Diode Laser): Use 100% Power and 5% Depth, 1 Pass

Settings 1

Engraving MethodPicture

MaterialStone

Resolution2 K

Power100%

Depth60%

Pass1

Module Type2 W 1064 nm