Open in LDS
Wooden Earrings
How-to
digermano
2024/07/23 22:32 66
1,5mm thick
Basic Information
| MachineLP2 |
| MaterialWood |
| Size27 x 34 mm |
| Production Time2 min |
| Engraving Difficulty |
How-to Tutorial
Step 1
You can use the image I put in the description, use Line or Cut mode depending on what application you use.
You will need to repeat the whole process unless you use LP Design Space.
Use the following settings: Power 100, Depth 30, Passes 3.
You can also directly use my G-Code with the same settings. No need to repeat the process.
When done, color as you wish. I got the earrings buckles from Amazon.
Have fun.
Settings 1
| Engraving MethodLine |
| MaterialWood |
| Power100% |
| Depth30% |
| Pass3 |
| Module Type5 W 450 nm |
| Other ParametersI used 1.5mm thick plywood. 2 passes are normally enough, but I rather use 3 to be sure everything is properly cut. |
Design Files
LaserPecker Design Space V2.5.1 or above is recommended.
Boucles Plumes.lp2
Open in LDSDownload
12
My Handmade Daily
Birthday Gift
DIY Assembly
Sharing Good Finds
Cutting
earring
