engraved some Rose Wood trophies
How-to
WINKER.INC
2024/04/10 20:31 0
I engraved some Rose Wood trophies for a friend who owns a fitness hub for a event they where holding called body hub beast time trials settings i used where 2k, 30 power, 20 depth, 1 pass without updated speed firmware.
Basic Information
How-to Tutorial
Step 1
quite enjoyed doing theses I did the middle section on the slide extension and the other 2 pieces normally did some test runs on some MDF to see how it came out before I did the trophies
Settings 1
| Engraving MethodFill |
| MaterialWood |
| Resolution2 K |
| Power30% |
| Depth20% |
| Pass1 |
| Module Type10 W 450 nm |
7
Good Life
My Handmade Daily
DIY Assembly
