Open in LDS
Engraving on denim / jeans
How-to
Jantsa
2024/02/05 04:30 41
Important: make jeans wet first. Put the jeans under the tap and wet them, then wring them out and then you can place then under laser for engraving.
Basic Information
| MachineLP4 |
| MaterialCloth |
| Size10 x 5 mm |
| Material InformationBlue jeans dress |
| Production Time4 min |
| Engraving Difficulty |
How-to Tutorial
Step 1 Important: make jeans wet first. Put the jeans under the tap and wet them, then wring them out.
Each denim though react differently, start first lower depth and power to test out. You can always make the second pass as well but not more than 2 as I have found with experience that 3 passes is already too much for the threads. This dress is made with one pass, but some jeans material stay too light with first pass and might need the second pass as well. When engraving on denim, a thicker design with not many fine lines will do better, as they will burn the threads, the laser is too sharp.
Settings 1
| Engraving MethodFill |
| MaterialCloth |
| Resolution1 K |
| Power50% |
| Depth2% |
| Pass1 |
| Module Type10 W 450 nm |
Design Files
LaserPecker Design Space V2.5.1 or above is recommended.
20
Decorative Painting
My Handmade Daily
Atmospheric Decoration
