Open in LDS
Wooden House Model
How-to
LaserPecker
2023/12/08 19:22 57
Let's make a wooden house model.
Basic Information
| MachineLX1 |
| MaterialWood |
| Size289 x 313 mm |
| Material Information3mm Basswood plank |
| Production Time40 min |
| Engraving Difficulty |
How-to Tutorial
Step 1
Begin by placing a 3mm basswood plank on the cutting plate. Adjust the focal length, verify the size, preview the position, and determine the engraving parameters. Once everything is set, proceed to start cutting.
Settings 1
| Engraving MethodCut |
| MaterialBasswood plank |
| Power70% |
| Depth80% |
| Pass1 |
| Acceleration Level1 |
| Module Type20 W 450 nm |
Step 2
Follow the steps shown in the pictures to assemble the wooden pieces and you will end up with a complete wooden house model.
Step 3 Note
This file is only applicable to 3mm basswood planks. Other thicknesses of wood may not be able to be assembled. Additionally, if you use different materials, you will need to adjust the parameters yourself.
Design Files
LaserPecker Design Space V2.5.1 or above is recommended.
Wooden House Mode.lp2
Open in LDSDownload
13
Wooden
House
Model
