Halloween Coaster Set

操作方法

Crafted Curiosity

United States2024/11/14 03:47 144

Set of 4 Halloween Designs (Witch, Mummy, Horseman, Vampire/Werewolf

基本信息

机器LP4

材质石材/Slate

尺寸101 x 101 mm

材料信息I used slate coasters purchased from Amazon. I did not pre-treat any of the coasters to get my end result.

制作时间60 分钟

雕刻难度

固件版本 <655

操作说明

步骤 1 Place Coasters on Engraving Plate and Size the Viewing Box to just go over the edge of the coaster

DO NOT Pre-Treat or Sand Coasters beforehand. (Coating Coasters Before Engraving Releases Fumes that are Seriously Harmful to your Health) Place Coasters on Engraving Plate and Size the Viewing Box area just enough to go over the edge of the coaster. Make sure each image is inverted and select dithering. Each coaster will take roughly an hour due to the amount of detail and shading. All images files are clearly marked (Mummy, Horseman, Werewolf and Vampire, Witch, and Witch-Pre Inverted and Ready to Etch) LP Sofware did not do as well with dithering levels on the not inverted version of the witch *Please use pre inverted image file for my results as this one already has contrast adjusted as well

FOR LP2 (5w Diode Laser): Use 100% Power and 5% Depth, 1 Pass

设置 1

雕刻方式图片雕刻

工艺材质石材

分辨率2 K

功率100%

深度60%

雕刻次数1

模块类型2 W 1064 nm

步骤 2 Rinse Coaster and Let Dry then Spray to Seal the Design

After each coaster finishes rinse them under water to remove any dust from etching. Once dry spray on a light layer of Mod Podge Matte sealer then let dry for about 20-30 minutes.