Cat Box
基本信息
操作说明
步骤 1
Ceramic tile coated with TiO2 using a foam brush, 2 coats. 1 Part TiO2, 3parts water, 1 part school glue. Add a wood frame and fit to the box. The box is made from 3mm plywood, the fame from 6mm plywood stained dark walnut and finished with 3 coats of polyurethane varnish. The box and frame are made using an Atomstack 20W laser.
设置 1
| 雕刻方式图片雕刻 |
| 工艺材质陶瓷 |
| 分辨率1 K |
| 功率50% |
| 深度90% |
| 雕刻次数1 |
| 模块类型10 W 450 nm |
| 其他参数Ceramic tile coated with TiO2 using a foam brush, 2 coats. 1 Part TiO2, 3parts water, 1 part school glue |
步骤 2 Metal cutting and inlay
Lay the tape GENTLY down on varnished wood surface, two coats, don't press hard or it will be difficult to weed. Don't worry about small wrinkles. They will be burnished out. Engrave on the tape. Carefully weed the design, Lay a piece of paper over the design, and strongly burnish the tape into the wood. This completely removes the wrinkles and firmly seals the tape to the wood. finish with a thin coat of varnish to further seal the edges of the tape.
设置 1
| 雕刻方式线条雕刻 |
| 工艺材质金属 |
| 功率100% |
| 深度98% |
| 雕刻次数3 |
| 模块类型2 W 1064 nm |
| 其他参数0.03mm Aluminum tape with heat resistant glue obtained from TapeBear |
步骤 3 Cut foam liner
Cut 2mm "Foamy" foam sheets to line the sides and bottom of the box. Note - power and depth depend on the color of the foam.
设置 1
| 雕刻方式切割雕刻 |
| 工艺材质塑料 |
| 功率100% |
| 深度90% |
| 雕刻次数1 |
| 模块类型10 W 450 nm |
| 其他参数2mm "Foamy" closed cell foam |
步骤 4 Engrave Foamy Bottom Liner
Probably can use a higher power and faster speed. Power and speed somewhat dependent upon color. Glue the foam in place with Elmer's Glue All.
设置 1
| 雕刻方式图片雕刻 |
| 工艺材质塑料 |
| 分辨率1 K |
| 功率24% |
| 深度94% |
| 雕刻次数1 |
| 模块类型10 W 450 nm |
| 其他参数2mm "Foamy" closed cell foam. Engraving done with Lightburn Software, Offset fill - Design Space doesn't have an offset fill mode. Probably a little deeper than optimum. |
