Halloween Coaster Set

ハウツー

Crafted Curiosity

2024/11/14 03:47 144

Set of 4 Halloween Designs (Witch, Mummy, Horseman, Vampire/Werewolf

基本情報

機器LP4

材質石材/

サイズ101 x 101 mm

材料情報I used slate coasters purchased from Amazon. I did not pre-treat any of the coasters to get my end result.

制作時間60 分

彫刻の難易度

ファームウェアバージョン <655

操作説明

ステップ 1 Place Coasters on Engraving Plate and Size the Viewing Box to just go over the edge of the coaster

DO NOT Pre-Treat or Sand Coasters beforehand. (Coating Coasters Before Engraving Releases Fumes that are Seriously Harmful to your Health) Place Coasters on Engraving Plate and Size the Viewing Box area just enough to go over the edge of the coaster. Make sure each image is inverted and select dithering. Each coaster will take roughly an hour due to the amount of detail and shading. All images files are clearly marked (Mummy, Horseman, Werewolf and Vampire, Witch, and Witch-Pre Inverted and Ready to Etch) LP Sofware did not do as well with dithering levels on the not inverted version of the witch *Please use pre inverted image file for my results as this one already has contrast adjusted as well

FOR LP2 (5w Diode Laser): Use 100% Power and 5% Depth, 1 Pass

設定 1

彫刻方法Picture

加工素材Stone

解像度2 K

電力100%

深さ60%

彫刻回数1

モジュールタイプ2 W 1064 nm

ステップ 2 Rinse Coaster and Let Dry then Spray to Seal the Design

After each coaster finishes rinse them under water to remove any dust from etching. Once dry spray on a light layer of Mod Podge Matte sealer then let dry for about 20-30 minutes.